text.skipToContent text.skipToNavigation
Display Kyocera 6.50 LED Upgrade
2096917-001
2094207-001 M1118320
New
Perinatale Versorgung
Autre Perinatale Versorgung
GE Healthcare
GE Healthcare
zum Wunschzettel hinzufügen
Im Shop anmelden
Im Shop anmelden
Please select date
Second Opinion Approval Needed

Enter your approval number and submit to add item(s) to cart.

Approval Number

Please enter approval number

OR

Don't know your approval number? Call 800-437-1171
Enter opt 1 for the first three prompts, and have your System ID available.

If you add item(s) to cart and submit your order without the
approval number, GE will contact you before your order
can be confirmed for shipment.

Second Opinion Approval Needed

Select your approver's name and submit to add item(s) to your cart

Approver Name

Please Select Approver Name

OR

Don't know your approval number? Call 800-437-1171
Enter opt 1 for the first three prompts, and have your System ID available.

If you add item(s) to cart and submit your order without
selecting an approver, GE will contact you before your order
can be confirmed for shipment.


Produktübersicht

The Display Kyocera 6.50 LED Upgrade is a service kit that consists of a LED display driver, LED backlit, cable tie, label and instruction for the LED display upgrade. The display Kyocera 6.50 LED is used for displaying the patients temperature and the air temperature of the Incubator. The LED board contains five display banks and two display drivers. The other driver controls the patient set temperature, air set temperature, warmer bar graph, and the mode and override indicators. This allows the two large displays (patient and air temperature) to be multiplexed at a slower rate than the other LEDs and this results in brighter large displays. To install the LED on control board first should be removed as part of the touch panel or LCD assembly. The control board should be placed on a flat surface and locate the CFL display driver, cut and remove the cable tie from the CFL display driver. Locate the LED driver board in the upgrade kit and the double sided tape. Install the LED driver board by first aligning the pins with the through-hole sockets in the control board. Then press the LED driver board in place, insert the pin perfectly and the double-sided tape is pressed fully against the control board surface. Finally, install the cable tie through the hole in the control board.

Vergleichbarer Artikel :

Below is more information on the equivalent parts. Parts without a hyperlink are listed for reference only and are not available for purchase online.

Vergleichbarer ArtikelArtikelbeschreibung
2094207-001

Assembly Kit Display Opitrex 6.50

M1118320 LCD DISPLAY
©2021 General Electric Company -Alle Rechte vorbehalten
Warenzeichen der General Electric Company
GE und GE Monogramm sind Warenzeichen der General Electric Company. GE Healthcare , ein Geschäftsbereich der General Electric Company.